Altera High-Speed Development Kit, Stratix GX Edition Uživatelský manuál Strana 37

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 140
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 36
Altera Corporation Quartus II Version 3.0 4–9
Run the Preloaded Diagnostic Tests Stratix GX HM-Zd SPI-4.2 Loopback
Figure 4–5. Install the HM-Zd SPI-4.2 Loopback Cards
4. Supply power to the board.
5. Confirm that the Stratix GX device has finished configuration (the
GX_CONF_DONE (D7) LED illuminates).
Run the Stratix GX HM-Zd SPI-4.2 Loopback Test
Perform the following steps to run the test.
1. Setthe Stratix GX dipswitch 5 to 1 (up position).
2. Press the reset pushbutton switch (GX_CLR).
3. Press the start pushbutton switch (Stratix_GX_PB_0). Several LEDs
illuminate.
LED0 is the high-speed data match LED. If it illuminates, the test
is successful.
LED1 indicates that the GX device has received the data.
Zobrazit stránku 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 139 140

Komentáře k této Příručce

Žádné komentáře