Altera High-Speed Development Kit, Stratix GX Edition Uživatelský manuál stáhnout pdf (Strana 25)

Altera Corporation Quartus II Version 3.0 3–3

Board Setup Required Hardware

Required

Hardware

To power up the Stratix GX development board, you need the hardware

listed in Table 3–2. See “Development Kit Contents” on page 2–1 for a list

of items provided in the kit.

Power Up the

Board & View

the XCVR Eye

Perform the following steps to power up the Stratix GX development

board. You will set switches on the board so that the Stratix GX device

displays the transceiver (XCVR) eye in an oscilloscope.

1 Before you attempt to power up the board, make sure that you

have the equipment listed in Table 3–2.

1. Set switch SW3 to off (middle position).

2. Connect one end of the ATX power supply to J31 and the other end

to a power outlet.

3. Set the Stratix GX device switches as shown in Table 3–3. These

settings display the XCVR eye.

4. Set switch SW3 to the on position (all of the way up). All of the

board LEDs illuminate.

Table 3–2. Required Equipment

Hardware Manufacturer Part Number Quantity

Stratix GX Development Board Altera 1

ATX Power Supply Sparkle Power FSP250-60GTA 1

Programming Cable Altera ByteBlaster II 1

SMA DC Block (1) Any 2

SMA 20-dB 50-Ω Attenuator (1) Any 1

High-Speed Digital Sampling Oscillocope (1), (2) Tektronix CSA8000 1

3-Foot SMA Cable (1) Any 3

Note:

(1) This item is required to view the XCVR eye.

(2) You can also use other oscilloscopes.

Table 3–3. Stratix GX XCVR Eye Switches Settings

SW1 SW2 SW4 SW5 SW8 J48 J90

YES NO EPC16 STD 000 X X

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 139 140

Žádné komentáře

Altera High-Speed Development Kit, Stratix GX Edition Uživatelský manuál Strana 25