Altera High-Speed Development Kit, Stratix GX Edition Uživatelský manuál Strana 29

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 140
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 28
Altera Corporation Quartus II Version 3.0 4–1
4. Run the Preloaded
Diagnostic Tests
Each interface on the Stratix GX development board has an associated
diagnostic test that exercises the interface at the supported I/O rates.
Although the tests are not exhaustive, they help you confirm that each
interface runs according to its intended design. A subset of the diagnostic
tests are loaded into the Stratix GX development board’s configuration
devices, making it easy for you to run any of the tests when you power
up the board. This chapter describes how to set up and perform these
preloaded diagnostic tests, including:
User I/O
Stratix GX Double Data Rate (DDR) SDRAM Interface
Stratix GX HM-Zd SPI-4.2 Loopback
Stratix GX HM-Zd XCVR Loopback
Stratix GX SFP XCVR Loopback
Stratix GX XCVR Eye Diagram
The following sections describe how to perfom each test, including the
equipment you need to perform each test, how to set up the board, and
the test procedure. Table 4–1 shows the switch settings you must make to
load the designs on power up. For more details on these designs, refer to
Chapter 7, Diagnostic Test Details.
User I/O
The user I/O design tests all of the user LEDs, dipswitches, pushbuttons,
and 7-segment displays on the board (the Stratix and Stratix GX devices
each have a set). One pair of pushbuttons controls each device’s user
Table 4–1. Factory-Default Switch Settings
Diagnostic Test SW1 SW2 SW4 SW5 SW7 SW8 (1) J48 J90
XCVR Eye Diagram YES NO EPC16 STD --- 000 X X
DDR YES NO EPC16 STD --- 011 X X
HM-Zd SPI-4.2 YES NO EPC16 STD --- 001 X X
HM-Zd XCVR Loopback YES NO EPC16 STD --- 001 X X
SFP XCVR Loopback YES NO EPC16 STD --- 001 X X
User I/O NO NO EPC16 STD 111 111 X X
Note:
(1) Slider 3 is the MSB and slider 1 is the LSB. A slider in the up position is 0 and a slider in the down position is 1.
Zobrazit stránku 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 139 140

Komentáře k této Příručce

Žádné komentáře