Altera Low Latency Ethernet 10G MAC Uživatelský manuál Strana 93

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 109
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 92
Signal Direction Width Description
avalon_st_rxstatus_
data[]
Out 40
Contains information about the RX frame.
Bits 0 to 15: Payload length.
Bits 16 to 31: Packet length.
Bit 32: When set to 1, indicates a stacked VLAN
frame. Ignore this bit when the MAC is
configured not to detect stacked VLAN frames
(tx_vlan_detection[0] = 1).
Bit 33: When set to 1, indicates a VLAN frame.
Ignore this bit when the MAC is configured not
to detect VLAN frames (tx_vlan_
detection[0] = 1).
Bit 34: When set to 1, indicates a control frame.
Bit 35: When set to 1, indicates a pause frame.
Bit 36: When set to 1, indicates a broadcast
frame.
Bit 37: When set to 1, indicates a multicast
frame.
Bit 38: When set to 1, indicates a unicast frame.
Bit 39: When set to 1, indicates a PFC frame.
avalon_st_rxstatus_
error[]
Out 7
When set to 1, the respective bit indicates the
following error type in the RX frame.
Bit 0: Undersized frame.
Bit 1: Oversized frame.
Bit 2: Payload length error.
Bit 3: CRC error.
Bit 4: Unused.
Bit 5: Unused.
Bit 6: PHY error.
The IP core presents the error status on this bus in
the same clock cycle it asserts the avalon_st_
rxstatus_valid signal. The error status is invalid
when an overflow occurs.
avalon_st_rx_pfc_
status_valid
Out 1 When asserted, this signal qualifies the avalon_st_
rx_pfc_status_data[] signal.
UG-01144
2014.12.15
Avalon-ST RX Status Signals
5-11
Interface Signals for LL Ethernet 10G MAC
Altera Corporation
Send Feedback
Zobrazit stránku 92
1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 108 109

Komentáře k této Příručce

Žádné komentáře