
DescriptionTypeParameter
the compensated clock output port of a PLL in source-
synchronous mode.
This parameter is ignored if it is applied to anything other
than an output or input pin as described above
Specifies the maximum value for the PFD pin. If omitted,
the default is 0.
IntegerPFD_MAX
Specifies the minimum value for the PFD pin. If omitted,
the default is 0.
IntegerPFD_MIN
Specifies the type of PLL to instantiate. Values are AUTO,
ENHANCED, FAST, TOP_BOTTOM and LEFT_RIGHT. If omitted,
the default is AUTO.
StringPLL_TYPE
Specifies the ACTIVECLOCK port connectivity. Values are
PORT_USED or PORT_UNUSED. If omitted, the default is PORT_
UNUSED.
StringPORT_ACTIVECLOCK
Specifies the ARESET port connectivity. Values are PORT_
USED or PORT_UNUSED. If omitted, the default is PORT_
UNUSED.
StringPORT_ARESET
Specifies the CLK[9..0] port connectivity. Values are PORT_
USED or PORT_UNUSED. If omitted, the default is PORT_
UNUSED.
StringPORT_CLK[]
Specifies the CLKBAD[1..0] port connectivity. Values are
PORT_USED or PORT_UNUSED. If omitted, the default is PORT_
UNUSED.
StringPORT_CLKBAD[]
Specifies the CLKENA[5..0] port connectivity. Values are
PORT_USED or PORT_UNUSED. If omitted, the default is PORT_
UNUSED.
StringPORT_CLKENA[]
Specifies the CLKLOSS port connectivity. Values are PORT_
USED or PORT_UNUSED. If omitted, the default is PORT_
UNUSED.
StringPORT_CLKLOSS
Specifies the CLKSWITCH port connectivity. Values are PORT
_ USED or PORT_UNUSED. If omitted, the default is PORT_
UNUSED.
StringPORT_CLKSWITCH
Specifies the CONFIGUPDATE port connectivity. Values are
PORT_USED or PORT_UNUSED. If omitted, the default is PORT_
UNUSED.
StringPORT_CONFIGUPDATE
Specifies the ENABLE[1..0] port connectivity. Values are
PORT_USED or PORT_UNUSED. If omitted, the default is PORT_
UNUSED.
StringPORT_ENABLE[]
ALTPLL (Phase-Locked Loop) IP Core User Guide
Altera Corporation
Send Feedback
ug-altpll
ALTPLL Parameters
56
2014.08.18
Komentáře k této Příručce