Altera 100G Development Kit, Stratix IV GT Edition Uživatelský manuál Strana 75

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 80
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 74
Chapter 2: Board Components 2–67
Power
September 2010 Altera Corporation 100G Development Kit, Stratix IV GT Edition Reference Manual
Power Measurement
There are 12 power supply rails which have on-board voltage and current sense
capabilities. These 8-channel differential 24-bit ADC devices and rails are split from
the primary supply plane by a low-value sense resistor for the ADC to measure
voltage and current. A serial peripheral interface (SPI) bus connects these ADC
devices to the MAX II CPLD EPM2210 System Controller as well as the Stratix IV GT
FPGA.
Figure 2–13 shows the block diagram for the power measurement circuitry.
Table 244 lists the development board power components and its manufacturing
information.
Figure 2–13. Power Measurement Circuitry
SCK
DSI
DSO
CSn
8 Ch.
To Plane 0x0
To Plane 0xE
Supply
0x0
Supply
0xE
R
SENSE
R
SENSE
SCK
DSI
DSO
CSn
8 Ch.
MAX II CPLD
Stratix IV GT
LTC2418
LTC2418
U52
EPM
240
USB
PHY
To User PC
Power GUI
JTAG Chain
SPI Bus
Embedded
USB-Blaster
U51
Table 2–44. Development Board Power Components (Part 1 of 2)
Reference
Designator
Device Description Manufacturer
Manufacturer
Part Number
Manufacturer
Website
J1
Right angle PC mount DC power jack
3-pin connector
Switchcraft, Inc. RAPC712X www.switchcraft.com
SW1 Slide switch E-Switch, Inc. EG2201A www.e-switch.com
U25, U26,
U27, U35,
U40, U42,
U43, U45,
U60, U68,
U69, U86
1.5-A low input voltage VLDO linear
regulator (1.14 V–5.5 V V
IN
, 0.4 V–2.6 V
V
OUT
)
Linear Technology LTC3026EDD#PBF www.linear.com
Zobrazit stránku 74
1 2 ... 70 71 72 73 74 75 76 77 78 79 80

Komentáře k této Příručce

Žádné komentáře