Altera Stratix V Avalon-ST Uživatelský manuál Strana 59

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 158
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 58
Figure 4-10: LMI Read
pld_clk
lmi_rden
lmi_addr[11:0]
lmi_dout[31:0]
lmi_ack
lmi_addr[8:0]
Figure 4-11: LMI Write
The following figure illustrates the LMI write. Only writeable configuration bits are overwritten by this
operation. Read-only bits are not affected. LMI write operations are not recommended for use during
normal operation with the exception of AER header logging.
pld_clk
lmi_wren
lmi_din[31:0]
lmi_addr[11:0]
lmi_ack
lmi_func[8:0]
Reset, Status, and Link Training Signals
Table 4-12: Reset Signals
Signal Direction Description
npor
Input Active low reset signal. In the Altera hardware example designs,
npor is the OR of pin_perst and local_rstn coming from the
software Application Layer. If you do not drive a soft reset signal
from the Application Layer, this signal must be derived from
pin_perst. You cannot disable this signal. Resets the entire
Stratix V Hard IP for PCI Express IP Core and transceiver.
Asynchronous.
In systems that use the hard reset controller, this signal is edge,
not level sensitive; consequently, you cannot use a low value on
this signal to hold custom logic in reset. For more information
about the hard and soft reset controllers, refer to Reset.
4-24
Reset, Status, and Link Training Signals
UG-01097_sriov
2014.12.15
Altera Corporation
Interfaces and Signal Descriptions
Send Feedback
Zobrazit stránku 58
1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 157 158

Komentáře k této Příručce

Žádné komentáře