Altera DisplayPort MegaCore Function Uživatelský manuál Strana 75

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 195
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 74
Required Hardware
The hardware demonstration requires the following hardware:
Altera FPGA kit (includes USB cable to connect the board to your PC); the demonstration supports
the following kits:
Stratix V GX FPGA Development Kit
Arria V GX FPGA Starter Kit
Cyclone V GT FPGA Development Kit
Arria 10 FPGA Development Kit
Bitec DisplayPort HSMC daughter card
PC with a DisplayPort output
Monitor with a DisplayPort input
Two DisplayPort cables
One cable connects from the graphics card to the FPGA development board
The other cable connects from the FPGA development board to the monitor
Note: Altera recommends that you first test the PC and monitor by connecting the PC directly to the
monitor to ensure that you have all drivers installed correctly.
The Bitec HSMC DisplayPort daughter card connects Altera FPGA devices to the DisplayPort source and
sink devices. High speed 5.4Gbps DisplayPort redrivers are used on both the source and sink signal paths
to improve signal integrity. The redrivers ensure close PHY layer compatibility at the DisplayPort
connectors.
Figure 6-6: Bitec HSMC Daughter Card
The figure shows a high level diagram of the Bitec HSMC daughter card.
TI
Redriver
DisplayPort
Connector
(Source)
Main Link
AUX
TI
Redriver
DisplayPort
Connector
(Sink)
Main Link
AUX
HSMC
Connector
The following figures illustrate the schematic diagrams of the Bitec HSMC daughter card.
6-14
Required Hardware
UG-01131
2015.05.04
Altera Corporation
DisplayPort IP Core Hardware Demonstration
Send Feedback
Zobrazit stránku 74
1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 194 195

Komentáře k této Příručce

Žádné komentáře