
4–2 Chapter 4: Development Board Setup
Factory Default Switch Settings
Cyclone V E FPGA Development Kit December 2014 Altera Corporation
User Guide
Factory Default Switch Settings
This section shows the factory switch settings (Figure 4–1) for the Cyclone V E FPGA
development board.
To restore the switches to their factory default settings, perform these steps:
1. Set the DIP switch bank (SW1) to match Table 4–1 and Figure 4–1.
Figure 4–1. Switch Locations and Default Settings
ON
SW1
ON
SW4
ON
SW3
ON
SW2
FPGA_MSEL0
FPGA_MSEL1
FPGA_MSEL2
FPGA_MSEL3
FAN_FORCE_ON
RESERVED
HSMC JTAG Enable
5M2210 JTAG Enable
CLK_SEL
CLK_EN
FACT_LOAD
SECURITY
Table 4–1. SW1 DIP Switch Settings
Switch
Board
Label
Function
Default
Position
1 FPGA_MSEL0
■ ON (0) = logic 0 is selected.
■ OFF (1) = logic 1 is selected.
ON
2 FPGA_MSEL1
■ ON (0) = logic 0 is selected.
■ OFF (1) = logic 1 is selected.
ON
3 FPGA_MSEL2
■ ON (0) = logic 0 is selected.
■ OFF (1) = logic 1 is selected.
ON
4 FPGA_MSEL3
■ ON (0) = logic 0 is selected.
■ OFF (1) = logic 1 is selected.
ON
Komentáře k této Příručce