Altera DE2-115 Uživatelský manuál stáhnout pdf (Strana 32)

 Configuring the FPGA in JTAG Mode

Figure 4-3 illustrates the JTAG configuration setup. To download a configuration bit stream into

the Cyclone IV E FPGA, perform the following steps:

• Ensure that power is applied to the DE2-115 board

• Configure the JTAG programming circuit by setting the RUN/PROG slide switch (SW19)

to the RUN position (See Figure 4-4)

• Connect the supplied USB cable to the USB Blaster port on the DE2-115 board (See Figure

2-1)

• The FPGA can now be programmed by using the Quartus II Programmer to select a

configuration bit stream file with the .sof filename extension

Figure 4-3 The JTAG configuration scheme

Figure 4-4 The RUN/PROG switch (SW19) is set in JTAG mode

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 120 121

Žádné komentáře

Altera DE2-115 Uživatelský manuál Strana 32