Altera Stratix V Advanced Systems Development Board Uživatelský manuál Strana 29

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 84
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 28
Chapter 2: Board Components 2–19
Configuration, Status, and Setup Elements
January 2014 Altera Corporation Stratix V Advanced Systems Development Board
Reference Manual
Setup Elements
The development board includes several different kinds of setup elements. This
section describes the following setup elements:
Board settings DIP switch
JTAG control DIP switch
PCI Express control DIP switch
MAX V reset push button
Program load push button
Program select push button
CPU reset push buttons
f For more information about the DIP switch settings, refer to the Stratix V Advanced
Systems Development Kit User Guide.
D10 RX
HSMC_RX_LED
Green LED. Blinks to indicate HSMC receive activity. Driven by
FPGA2.
D11 TX
HSMC_TX_LED
Green LED. Blinks to indicate HSMC transmit activity. Driven by
FPGA2.
D21 PRSNTn
HSMC_PRSNTn
Green LED. Illuminates when the HSMC port has a board or
cable plugged-in such that pin 160 becomes grounded. Driven
by the add-in card.
D1, D2, D3 PGM_LED[2:0]
PGM_LED0
PGM_LED1
PGM_LED2
The sequence displayed determines which design is used to
configure the FPGAs from flash when you press the PGM_LOAD
push button. Refer to Table 2–7 for the push button
configuration settings.
D26
OVERTEMP
FPGA1
FPGA1_OVERTEMPn
Red LED. Illuminates when a heat sink or fan should be installed.
Driven by the MAX1619 thermal sensor
FPGA1_OVERTEMPn
signal.
D37
OVERTEMP
FPGA2
FPGA2_OVERTEMPn
Red LED. Illuminates when a heat sink or fan should be installed.
Driven by the MAX1619 thermal sensor
FPGA2_OVERTEMPn
signal.
Table 2–8. Board-Specific LEDs (Part 2 of 2)
Board
Reference
LED Name
Schematic Signal
Name
Description
Zobrazit stránku 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 83 84

Komentáře k této Příručce

Žádné komentáře