Altera Cyclone II EP2C35 PCI Development Board Uživatelský manuál Strana 23

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 50
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 22
Altera Corporation Core Version 4.0.0 2–13
May 2005 Cyclone II EP2C35 PCI Development Board Reference Manual
Board Components & Interfaces
Push-Button Switches
Table 2–15 describes the board’s push-button switches.
Figure 2–3 shows the boards push-button switch circuitry.
Figure 2–3. Board Push-Button Switches
Table 2–15. Push-Button Switches
Board
Reference
Reference
Designator
Description
RECONFIG S2 Causes Cyclone II device to reload configuration
RESET S3 User-defined hardware reset.
PB0 S1 User-defined. These switches are momentary-contact, push-button switches that
provide stimulus to designs in the Cyclone II device. Each switch is connected to
a Cyclone II general purpose I/O pin with a pull-up resistor. When a switch is
pressed, the Cyclone II device pin will detect a logic 0; when the switch is not
pressed, the Cyclone II device pin will detect a logic 1. The push-button switches
are tied high with a pull-up resistor.
PB1 S5
3.3 V
1
1
1
1
2
2
2
2
S2
S3
S5
S1
RECONFIG
RESETn
USER PB1n
USER PB0n
R35
10K Ω resistors
R40
R33
R34
Zobrazit stránku 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 49 50

Komentáře k této Příručce

Žádné komentáře