Altera ALTDQ_DQS2 Uživatelský manuál Strana 57

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 100
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 56
Legend in Figure 19 Bit Bit Name Description
H 9..5 dqsenablegatingdelaysetting Connects to the delayctrlin port
of the postamble T11 delay
chain (gated). Aligns the
postamble signal in terms of
DQS signal by selecting
different delays.
I 10 enadqsenablephasetransferreg Connects to the enaphasetrans‐
ferreg port of the DQS Enable
Control block to allow an
additional negative edge-
triggered register to be added to
the DQS enable control path to
satisfy the setup or hold time
requirement for the phase
transfer.
J 15..11 octdelaysetting Connects to the delayctrlin port
of the D5 delay chain.
Controls the dynamic OCT
output register-to-I/O buffer
delay chain (D5).
For delay values, refer to the
“Programmable IOE Delay”
sections in the Arria V Device
Datasheet and the Cyclone V
Device Datasheet, respectively.
K 16 dqshalfratebypass Sets the multiplexers in the DQS
enable logic, OCT logic, and
FIFO control logic to
dynamically switch from half-
rate to full-rate configuration.
L 21..17 dqsbusoutdelaysetting Connects to the delayctrlin port
of the read DQS D4 delay chain.
Controls the delay tuning of the
DQS signal feeding into the
DQS bus.
UG-01089
2014.12.17
DQS Configuration Block Bit Sequence for Arria V and Cyclone V Devices
57
ALTDQ_DQS2 IP Core User Guide
Altera Corporation
Send Feedback
Zobrazit stránku 56
1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 99 100

Komentáře k této Příručce

Žádné komentáře