Altera Stratix IV E FPGA Development Board Uživatelský manuál Strana 30

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 72
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 29
2–22 Chapter 2: Board Components
Clock Circuitry
Stratix IV E FPGA Development Board Reference Manual May 2011 Altera Corporation
Rotary Switch
The 16-position rotary switch (SW5) is wired to the MAX
II CPLD EPM2210 System
Controller. This rotary switch serves the following purposes:
At power-up or when the reset configuration push-button switch (S1) is pressed,
this switch selects either the factory (page 0) or the user (page 1) design to load
into the FPGA. The FPGA reconfiguration can also be done by writing a logic 1 to
the
srst
register over the FSM bus in the MAX
II CPLD EPM2210 System
Controller.
After power-up, the rotary switch selects the power rail monitored from among a
total of 12 rails. The power information is displayed in the Power GUI on a host PC
with a USB connection to the board.
User applications can obtain the switch value by reading the
rsr
register over the
FSM bus in the MAX
II CPLD EPM2210 System Controller.
Refer to Table 2–53 on page 2–59 for the specific power rails that are measured based
on the rotary switch position.
Table 221 lists the rotary switch component reference and manufacturing
information.
Clock Circuitry
This section describes the board's clocking circuitry.
Stratix IV E FPGA Clocks
The development board has several on-board oscillators.
Table 2–21. Rotary Switch Component Reference and Manufacturing Information
Board Reference Description Manufacturer
Manufacturer
Part Number
Manufacturer
Website
SW5 16-position rotary switch Grayhill 94HCB16WT www.grayhill.com
Zobrazit stránku 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 71 72

Komentáře k této Příručce

Žádné komentáře