Altera Stratix III Uživatelský manuál Strana 18

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 34
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 17
4–4 Chapter 4: Development Board Setup
Configuring the FPGA
Stratix III Development Kit User Guide © August 2008 Altera Corporation
To configure the Stratix III FPGA, perform the following steps:
1. Verify that the 4-position SW1 mini-DIP switches and the two jumpers are set to
the default positions shown in Table 42.
2. Connect the USB cable to the development board USB port.
3. Cycle the POWER switch OFF then ON.
4. Start the Quartus II software.
5. On the Tools menu, click Programmer. The Quartus II Programmer appears.
6. Click Add File and select <path>\examples\stratixIII_3sl150_dev_my_first_fpga
\stratixIII_3sl150_dev_my_first_fpga.sof.
7. Turn on the Program/Configure option for the added file.
8. Click Start to download the selected file to the FPGA. The FPGA is configured
when the progress bar reaches 100%.
9. Confirm that user LEDs 0-3 flash in a slow binary counting pattern.
Zobrazit stránku 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 33 34

Komentáře k této Příručce

Žádné komentáře