Altera Stratix GX Transceiver Uživatelský manuál Strana 198

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 318
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 197
6–44 Altera Corporation
Stratix GX Transceiver User Guide January 2005
Design Example
altgxb_component.preemphasis_ctrl_setting = 0,
altgxb_component.loopback_mode = "SLB",
altgxb_component.use_channel_align = "OFF",
altgxb_component.intended_device_family =
"Stratix GX",
altgxb_component.use_equalizer_ctrl_signal =
"OFF",
altgxb_component.rx_enable_dc_coupling = "OFF",
altgxb_component.run_length_enable = "OFF",
altgxb_component.pll_use_dc_coupling = "OFF",
altgxb_component.operation_mode = "DUPLEX",
altgxb_component.use_8b_10b_mode = "ON",
altgxb_component.use_rx_clkout = "OFF",
altgxb_component.data_rate_remainder = 0,
altgxb_component.data_rate = 1280,
altgxb_component.align_pattern = "P0101111100",
altgxb_component.use_rx_cruclk = "OFF",
altgxb_component.number_of_quads = 1;
endmodule
Simulation Waveform & Hardware Verification Results
Figures 6–34 and 6–35 show the complete synchronization sequence from
the transmitter to the receiver for the SignalTap
®
II logic analyzer and the
Quartus II software, respectively. The GigE duplex channel is configured
in a serial loopback mode. The synchronization pattern is sent by the
transmitter. The receiver sends a K28.4 character (8’ b9C + ctrl) until
synchronization is achieved. Although any odd number of valid /Dx.y/
codes is supported between each /K28.5/ code, one /Dx.y/ is shown in
this example.
The 8’h00 shown on the rx_out bus results from the reset pulse when
the pipelined registers are reset in the receiver block.
There is good correlation between the SignalTap II logic analyzer results
and the Quartus II software simulation.
Figure 6–34. GigE Synchronization Sequence SignalTap II Results
Zobrazit stránku 197
1 2 ... 193 194 195 196 197 198 199 200 201 202 203 ... 317 318

Komentáře k této Příručce

Žádné komentáře