Altera MAX 10 FPGA Uživatelský manuál Strana 28

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 56
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 27
Related Information
.pof Generation through Convert Programming Files on page 3-6
Provides more information about how to set th weak pull-up during configuration.
Power Up
If you power-up a device from the power-down state, you need to power the V
CCIO
for bank 1B and 8 to
the appropriate level for the device to exit POR.
To begin configuration, the required voltages must be powered up to the appropriate voltage levels as
shown in the following table. The V
CCIO
for bank 1B and bank 8 must be powered up to a voltage between
1.5V – 3.3V during configuration.
Table 2-19: Single-Supply and Dual-Supply Voltage Requirements for MAX 10 Devices
Power Supply Device Options Voltage that must be Powered-Up
Single-supply
Regulated V
CC_ONE
V
CCA
V
CCIO
bank 1B and bank 8
Dual-supply
V
CC
V
CCA
V
CCIO
bank 1B and bank 8
Related Information
MAX 10 Power Management User Guide
Provides more information about power supply modes in MAX 10 devices
MAX 10 Device Datasheet
Provides more information about the ramp-up time specifications.
MAX 10 FPGA Device Family Pin Connection Guideline
Provides more information about configuration pin connections.
Instant-on
The MAX 10 devices support instant-on feature. The instant-on mode is the fastest power-up mode for
MAX 10 devices.
If you enable instant-on, the device will directly enter the configuration stage. The POR delay value will be
used to delay the POR signal if the instant-on feature is not enabled.
Table 2-20: Instant-On Power Up Sequence Requirement for MAX 10 Devices
Power Supply Device Options Power Up Sequence
Single-supply V
CCIO
must ramp up to full rail before V
CCA
and V
CC_ONE
start ramping
Dual-supply All power supplies must ramp up to full rail before V
CC
starts ramping
2-24
Power Up
UG-M10CONFIG
2015.05.04
Altera Corporation
MAX 10 FPGA Configuration Schemes and Features
Send Feedback
Zobrazit stránku 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 55 56

Komentáře k této Příručce

Žádné komentáře